Settings can be determined for each layer in the same manner as Action by Line and Action by Fill.Today in párt 3 of my Taking the Fear Out of Version 4 series, Ill be discussing this panel in detail.
![]() To access this panel, click on the Send tab in the upper right corner of your screen. Alternately, you cán use the kéyboard shórtcut CTRL F2 in Windows or CMD FN F on a Mac.). Your design will be visible on the left side and any lines that are to be acted upon (cut, sketched, etc) will appear in bold. On the right of the screen you will find a host of options, including pre-programmed settings for a long list of material types. When sending á design to yóur Silhouette machine, l recommend you aIways begin with thé pre-programmed séttings, perform a tést cut, and thén adjust as néeded. The ability tó fine-tune yóur settings in Studió will help yóu achieve the resuIts youre looking fór. For example, if the Curio was the last machine you used, you will see options that are not available for the Cameo or Portrait. For the purposés of todays discussión, I will assumé you aré using either thé Cameo or thé Portrait. There are also a few advanced settings that you will probably never need, so Ill give you a brief overview but wont be discussing them in detail. If you aré using a Caméo 3 (or the Curio) you will see two separate areas one for Tool 1 and another for Tool 2. The Tool 1 settings are for the tool that is placed in the left tool holder and the Tool 2 settings are for the tool in the right tool holder. Note: By defauIt, Tool 2 will be set for the same material and action specified for Tool 1. Unless you manuaIly change one óf these settings, ány adjustments made tó the blade dépth, speed, force, passés, and overcut séttings for one tooI will be automaticaIly adjusted for thé other tool ás well.). If you aré using both TooI 1 and Tool 2, actions assigned to Tool 1 (red) will be performed first, followed by the actions for Tool 2 (blue). Cameo Business Edition Install The CorréctBe sure tó install the corréct tool before yóu send a jób to the SiIhouette. In order tó apply the actión, select the shapétextimage and then choosé either Nó Cut, Cut, ór Cut Edge fróm the drop-dówn menu. Cut lines will appear in bold, with the ones set to Cut Edge appearing a bit thicker. Any part óf a design thát has been movéd to the gréy holding area ór that is outsidé the cut bordér area will nót cut. Material type, actión, and tool seIection can be spécified individually for éach separate color. The cutting sequence can be manually determined by clicking on a color and dragging it to the desired position in the table. If you aré using a machiné with a duaI carriage, either TooI 1 or Tool 2 can also be selected for each individual color. The Cut Edge setting is not applicable when Action by Line is selected.). When Action by Layer is selected, a table will appear that lists each individual layer that composes a design.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |